Frigidaire Ice Maker Will Not Dump Ice

One component of the ice maker assembly might be defective.

Frigidaire ice maker will not dump ice.

I can initiate the dump sequence and it will process the ice out but it will not do it. The gear box turns very slowly but has lots of power to push the ice. My icemaker will not dump the ice. It is getting the water and it freezes but will not dump the ice.

O normally open and when cold from the ice in the mold it will close which tells the motor to dump the ice. The water despenser works great and water is getting to the icemaker too. Refrigerator parts available on amazon ice makers check the ice maker parts with a multimeter. I also changed the water filter.

I have a frigidaire refigerator that is 8 years old and the ice maker is not working. This thermostat is n. There is usually an arm attached to the ice maker that raises as the ice fill the bucket below. Before replacing the ice maker assembly check the water inlet valve water line and fan.

This heating element may be burnt out. Use a multimeter and check the ice maker mold thermostat ice maker mold heater and the ice maker module for faults to see if this is causing the ice cubes to not drop. If none of these parts are at fault and the freezer. We have had the water valve replaced and the air humidifier replace and the ice maker unit.

The ice bucket auger is located in the ice bin and when the dispenser is activated will rotate to pull the ice forward to the outlet chute of the bin. Since many of the ice maker components are not sold separately you may need to purchase and replace the entire ice maker assembly. If you ve chosen cubes but get crushed ice instead there s no need to. Some ice makers heat a little so they can release the ice to dump.

The auger is driven by a motor mounted behind the bin with a set of drive forks on the gear box shaft. Whirlpool refrigerator model gz25fsrxyy2 our ice maker is no longer dumping the ice it makes i think the ice maker mold thermostat may need to be replaced. If this arm is in the raised position it will not make or dump additional ice.